Versions Compared

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

...


Read the white paper: https://drive.google.com/open?id=10kpqi9yJM6gZ7E_YhkmHX6g0pSOTL0KB


Table of Contents

Quick Overview

Rear panel

  • Reset switch
  • Power supply
    • Input: AC100V~240V, 50/60Hz
    • Output: DC 12V, 1.5A
  • Network ports
    • 2 Ethernet ports RJ-45, 10/100 base-T
      • 1 WAN port
      • 1 LAN port configured in Bridge
  • FXO ports
    • 4 analog ports RJ-11

...

  • 1 Power LED indicating that the gateway is powered
  • 1 Status LED indicating that the gateway functions
  • 1 Proxy LED indicating that the gateway is registered on SIP proxy
  • 1 LAN LED indicating that the gateway is connected to the network via this port
  • 1 WAN LED indicating that the gateway is connected to the network via this port
  • 4 LEDs Line1…Line4 indicating that the activated analog ports are connected:
    • blinking LED indicates that the line is activated but not connected
    • LED is ON indicates that the line is busy in the conversation
    • LED is OFF indicates that the line is connected and free

Connection to power supply (old models without PoE)

Connect the gateway using the power supply and the cable provided with the gateway, as it is shown on the picture:


PDF avoid Pagebreak

Connection to Ethernet

The gateway has one LAN port configured in Bridge mode and one WAN port set up as a DHCP Client. Connect one of two ports to the same network as the PBX or an external DHCP server (for instance, its router) as shown on the picture:

...

  • In case the PBX is used as a DHCP server, the gateway is detected on the network automatically
  • In case an external DHCP server is used, check the list of the active leases to detect the IP address assigned to the gateway

Connection to the line

W04FXO gateways have 4 ports on the rear part of the devices, marked as Line1, Line2, Line3, Line4. Connect the needed ports to the analog lines.


PDF avoid Pagebreak

Provisioning of the gateway

Follow our online Guide to provision the FXO gateway.

For remote/unreachable media gateways behind NAT/Firewall, follow our online Guide to remote provisioning.

Edit the trunk parameters

Follow our online Guide to correctly set up the trunk parameters of the FXO gateway.

Reset of the gateway

In case you need to reconfigure the gateway, you should perform a reset procedure, as shown on the picture. The switch marked as “Reset/Default” is situated on the rear panel of the gateway.

...